NCam v1.5-r0 Compiled: 04.04.2017 - Changelog v1.5-r0: - Added support for i686.exe. - Added NodeID generator to CCcam. - Fixed issue reported on new options in loadbalanced. - Small arrangements in the webif in different areas (little appreciable).
Important notice!! - This is the OFFICIAL version - 02.04.2017 - There are no later versions. Changelog v1.4-r0: - Added support for stapi5. - New config somewhat more globalized (If you have cuts, adjust the config to your needs). - Increased values of ECM FMT LEN, CXM FMT LEN, and MAX ATR LEN. - Compiled with new FLAGS to avoid problems in 4k architectures. Thanks to LonasDigital Team!!
Changelog v1.1-r2: - Added support for CCcam.cfg native. - Added new option auto block sid in CCcam. - Added support for auto restart reader after some time and extend reset cycle for network reader. - Added friendly output debug message for CCcam. - Added Support for streamguard. - Update jquery-3.2.0 - Upgrade reader tongfang. - Support httputf8 webif (on/off). - Added latest OScam patchs till the date 18-03-2016. - Tandberg ecm and emm algorithm fix. - Added support radegast. - Added Ping time feature. - Added MAX accepted ECM time. - Added Support for never retry failed load balanced things. - Define which client can use option force reopen. - Improved logging and enabled debug mode again. - Live log active. - Changes in webif status. - New option of services in the reader to select a reader in priority. - Added option ECM timeout limit. - Fix N*D*S CWs are dropped when connected to real CCCam servers. - Increase to 128 the service limit. - Increase ECM length and Fix check sec len for some large ecm data. - Fix card matching for prov is 0 in CCcam. - General Arrays in CCcam Protocol, now works more like the native CCcam. - Arrangements to reduce blockages and freezes. - Support for Rasp pi 3 (Prismcube uses this same binary). - Fixed the problem of anticascading. - Fix for aggressive-loop-optimizations warnning. - Add extended allowed timeframe request. - Accept all providers when provider is not specified - Add full support for multiport supported by Cs378x. - add support AES key to dvbapi and newcamd - Completely reconfigured by default. Do not forget to redo your config.
EMULATOR - CCcam Channel Info - Prio 31/07/2016 - NC + 0100 NC + 0B01 NC + (MIX) Cyfrowy Polsat (1803) Cyfrowy Polsat (1861) TNK TNK Smart HD TNK HD Orange PL CS Link Mtv Unlimited Sky Link Sky IT Sky DE Nova Greece Canal+ esp TeleSat Canalsat Sky Digital (UK) HD+ Canal Digitaal TV Vlaanderen Bis TNT Austriasat SSR/SRG Orf Canal Digital Nordic Viasat Elite HD 10+ FreeX TV SCT & Penthouse HD